Some Fast Facts About Water Jet Cutting

With water jet cutting becoming so widely used, it only makes sense that you might be interested to know more about it. It’s fascinating how water alone can be enough to cut through hard materials, and it even sounds impossible if you haven’t heard of these machines before.

Therefore, if you would like to know more about these units, below you will find some interesting facts about them.

Pixabay

  1. They Use Less Water than Water Hoses

You might think that a lot of water is needed to be able to cut through stainless steel but, in reality, the amount is lower than the one required by a water hose. A water jet cutter will use around 0.5 or 1 gallons of water per minute. So, even if the water has to be sprayed with extremely high pressure, there’s essentially less water consumed.

  1. Accuracy May Be Lost with Tubes, Honeycombs, Voids, and Bundles

Although highly accurate in terms of cutting,  with water cutting machines the stream of water will diffuse when it has to cut through tubes, as there are voids. So, the cutting ability will instantly decrease. At the same time, fibrous materials won’t be too good either, as the cutting ability will get worse since the material will act like honeycombs.

  1. It Cuts through Pretty Much Most Materials

The great thing with water jet cutting is the variety of materials it can cut through. From paper to plastic, foam, wood, rubber, ceramics and even steel and stone, this cutting technique can operate with no issues. Of course, not all materials in the world can be cut with a water jet. Some exceptions are tempered glass and diamonds.

  1. Water Jet Cutting Has Been Around since the 1800s

Water jet cutting isn’t a new invention. Actually, it was invented back in the mid-1800s and has since started to develop over the years, until it reached the point it’s in today. Although it has been established in the middle of the 1800s, water jet cutting only joined the manufacturing industry a little less than a century later.

Final Thoughts

It’s always nice to find out more about the machines you’re using, as it puts them into a new light. All these facts make water jet cutting units unique and might also make you more eager to use them. We hope that you’ve found these facts interesting.

Comments are closed.